Front clearance

[Blue T/A 2.0]

My 15 TA has 4 1/4" clearance from the bottom of the scuff pad. I don't recall my Gen 4 ACR clearance, but I think the TA is lower. Anybody know?

[ViperSmith]

My stock SRT has 5'' clearance at min (undercarriage)

[mjorgensen]

My 15 TA has 4 1/4" clearance from the bottom of the scuff pad. I don't recall my Gen 4 ACR clearance, but I think the TA is lower. Anybody know?

We have seen a WIDE range of ride heights on the TA's in general, the tolerance is +- 1/2".

[bluesrt]

they will settle a lot after around 1,000 miles

[ddominator1]

so question.. if settles a bit more after a couple thousand miles is it worth it to put caps on or will that cause clearance issues / scraping?

[mjorgensen]

so question.. if settles a bit more after a couple thousand miles is it worth it to put caps on or will that cause clearance issues / scraping?

If you are worried I would give it some time to settle then decide, we have done a few cars and they were pretty low compared to others.

[coomer00]

We have seen a WIDE range of ride heights on the TA's in general, the tolerance is +- 1/2".

Mark , can you recommend ride heights for a 2010 ACR-X dedicated track car . Where do you specifically measure these on the vehicle ? The wheels are 18 inch all round with 315 Front and 345 Rear Hoosiers -what pressure should the tires be at when measuring? I normally run at 34 PSI hot?
Thanks
Richard.

[mjorgensen]

Ride heights are measured frame to ground between the front tires and the rears 4 total measurments. On the X 4" front is a good start. You don't want the splitter much less than 3" off the ground, there should be 1.25 -1.5" of rake also. I always make measurments with tires at operating pressures.

Mark , can you recommend ride heights for a 2010 ACR-X dedicated track car . Where do you specifically measure these on the vehicle ? The wheels are 18 inch all round with 315 Front and 345 Rear Hoosiers -what pressure should the tires be at when measuring? I normally run at 34 PSI hot?
Thanks
Richard.