Picture request of the TA 1 wing showing exact placement

[chris_lee]

Looking for a picture showing exactly how close to the edge the factory placement of the TA 1 wing is. Every picture I find is a bit to far to tell. Thanks in advance

[Sniper]

Not factory but I placed mine exactly on the edge of the rear lip.
I’m very anal about the way things look and I made sure every edge lined up to rear lip even the sides…

version=1&uuid=00000000-0000-0000-0000-000000000088&mode=compatible&noloc=1.jpg
version=1&uuid=00000000-0000-0000-0000-0000000000A6&mode=compatible&noloc=1.jpg
version=1&uuid=00000000-0000-0000-0000-0000000000CA&mode=compatible&noloc=1.jpg

[Lawineer]

Same. It would look odd not following the edge.

[chris_lee]

Perfect! Thanks guys. Looks like it pretty much goes right up to where the rounding of the edge starts.

[Hawk]

Here’s is mine and a pic of how the adhesive was when I removed it
P1015088.jpg
P1015091.jpg
P1015092.jpg

[mblgjr]

Here’s is mine and a pic of how the adhesive was when I removed it
P1015088.jpg
P1015091.jpg
P1015092.jpg

Was the oem adhesive tape or epoxy?

[Hawk]

I think it was an epoxy, hard to tell after I cut thru it with fishing line. It also seemed not uniform enough for tape
I would think the tape would work fine if the trunk lid and wing was cleaned well

[chris_lee]

3M window weld is what is recommended. It appears to be what the OEM was installed with. But, I’ve seen 3M tape used as well. I went with 3M window weld as the urethane is supposed to bond really well to the slight remaining amount from the previous install.