To anyone who has installed this kit that might be of assistance. I tried installing the 2" seat lower kit in a 2017 ACR viper recently. I'm having a bit of an issue and a couple questions. In the instructions, it explains to remove the seat belt receptacle from the seat and move it to the trans tunnel. Would that mean I'm going to need to drill a hole in the trans tunnel, raise the car and remove the bottom access cover in order to put a nut on the other side of the trans tunnel to hold the bolt going through the belt receptacle? Also, no nut or bolt was provided with the kit correct? Without removing the belt receptacle, I can't get the rear bolt holes to light up, and even with it removed it appears to be quite a task possibly to align the bolt holes and reach behind the seat to tighten the nuts.

Secondly, is the reason for removing this belt receptacle due to the seat not fitting down all the way to mount the seat due to it pushing the seat too far away from the trans tunnel?

Lastly, there was a sensor clipped onto the slide rail of the driver seat that I removed. I'm not sure if this is the sensor to tell the car if I'm sitting in the seat or not, but if it is what do I do with that? It was never mentioned in the instructions that I could see, but can I just leave it behind the seat unattached?