Xtreme Supercars CF Spoiler

[Sniper]

Does anyone have instructions how to install this spoiler so it is positioned correctly?
It is held on by tape so once you lay it down on the car, that’s where it’s going to be, aligned or not so you only have one shot...

[BJG32]

Same idea below. Dry fit, mark the tape, peel install.

Use spritz of rubbing alcohol on the car to temporarily keep the tape from sticking until positiond right. Try as best you can to set in place without needing to move it.

https://driveviper.com/forums/thread...r-Installation

[Sniper]

I couldn’t use those instructions as this being taped on so I improvised.
I got the spoiler in place where it was all aligned up and then I used stick on felt pads to stick on the car to hold the spoiler from moving towards the front of the car and to align the spoiler once I stuck on car.
I also used the tape method to align middle of spoiler up.
I then put the spoiler slowly down as my wife told me to move right or left to align with tape.
Ended up perfect.
I just don’t know how long I was supposed to hold the spoiler down for the tape to fully adhere. I held it down for about a minute.

FD76F137-09FE-4F9D-80FA-131BD1227549.jpg

[Hamrhead]

Damn that looks good!

I want one for my '15 bad...

[ViperGeorge]

I couldn’t use those instructions as this being taped on so I improvised.
I got the spoiler in place where it was all aligned up and then I used stick on felt pads to stick on the car to hold the spoiler from moving towards the front of the car and to align the spoiler once I stuck on car.
I also used the tape method to align middle of spoiler up.
I then put the spoiler slowly down as my wife told me to move right or left to align with tape.
Ended up perfect.
I just don’t know how long I was supposed to hold the spoiler down for the tape to fully adhere. I held it down for about a minute.

FD76F137-09FE-4F9D-80FA-131BD1227549.jpg

Your method seems to have worked well. Looks great!

[Sniper]

Is it true carbon fiber has to have weep holes to evacuate humidity in hot temps?

[ACR-ISH]

Is it true carbon fiber has to have weep holes to evacuate humidity in hot temps?

Fiberglass and carbon typically both do...