Moton Install

[pokeyl]

Fronts this week. Rears next week. Test drive soon, its raining!

IMG_0118.jpg

IMG_0119.jpg

[Mamba003]

Those look like the three way. Nice. Just so you know you should be able to access the canister schrader valves to adjust/check pressure. Not sure you will be able to the way they are mounted.

[steve911]

It is definitely not good to mount directly behind the rad fan where the reservoirs will get blasted by 200 degree air all of the time. Plenty of other places to mount to be cooler and to be able to service the reservoir.

[pokeyl]

The only other solution I saw was to mount them on the cross-brace, also in the nice warm engine bay (only pic I could find). In the wheel wheel would be good but there is no space. The void under the head light? I am open to ideas. Thanks in advance.

It is definitely not good to mount directly behind the rad fan where the reservoirs will get blasted by 200 degree air all of the time. Plenty of other places to mount to be cooler and to be able to service the reservoir.

[pokeyl]

It is definitely not good to mount directly behind the rad fan where the reservoirs will get blasted by 200 degree air all of the time. Plenty of other places to mount to be cooler and to be able to service the reservoir.

Took you advice

IMG_0173.jpg
You can reach in front of the wheel, mounted horizontal (up front)

IMG_0175.jpg
Rear are behind mounted vertical

Running 400 lbs/inch front, 800 lbs/inch rear 2 clicks from full soft rebound and compression (120 PSI precharge)

[RedTanRT/10]

Pokely, here's how I did mine. There was a guy on the boards (from NY?) that sold these brackets. Not sure if he's still around



aaa 5.jpg