ACR Rocker Panel Question

[Alex Rebuilds]

Is the ACR Rocker Panel Side Sill Insert different hole size wise from just a regular GT Side Sill Insert? I know the color is different but is the actual hole any bigger where the Exhaust tip goes in? Tried doing some research online and they appear to be but just wanted to make sure? Any input would be greatly appreciated!

[ForTehNguyen]

ACR has different exhaust bezels. The ACR factory exhaust is more round where the other vipers exhaust tips are oval

non ACR:
https://partsonlinenetwork.com/index...il-pipes-5576/

ACR bezel (fyi not a factory exhaust tip) then look at post 9:
https://driveviper.com/forums/thread...on-my-2016-ACR

[Alex Rebuilds]

ACR has different exhaust bezels. The ACR factory exhaust is more round where the other vipers exhaust tips are oval

non ACR:
https://partsonlinenetwork.com/index...il-pipes-5576/

ACR bezel (fyi not a factory exhaust tip) then look at post 9:
https://driveviper.com/forums/thread...on-my-2016-ACR

Thanks for the info. The ACR bezels will fit on a NON ACR Rocker correct? I believe the part #s are the same for the Rockers

[ForTehNguyen]

i do not know, sorry, i assumed they came as a single piece

[Martin]

I think the ACR bezels will fit on the non ACR side-sills. I haven't personally tried it, but I've seen them side by side and they appear to be the same dimension. Beware that if you're installing an ACR type exhaust, you may want to tack weld the exhaust tip in place. For some reason, just about every one I've seen has the exhaust tip rotated down and ends up burning the bezel.

[Jack B]

Be careful when removing the bezel, the screws are hard to remove without shearing them off.

[DZnutz]

The 2 are NOT interchangeable

[Fursty]

The rocker panels for an ACR are totally different vs a Non ACR.
The Non ACR has an insert that goes into an oval shaped opening, but the ACR is just a round opening.

C21CF8F5-CDC0-41CE-B80D-6B687571DD2E.jpg

[Fastbusy]

I burnt the bottom of my side sill on my GTC/ACR after the exhaust tip rotated down during a track outing. Since then I've had the exhaust tip(s) tacked into place. I thought that the immediate exhaust tip surround may have been a modular piece but it appears not. Is this aluminum? Is body work an option?

image2.jpg