Snap Nut Part Number Needed Sill Panel

[Gen5snake]

Hello - I can't find the part# for the 3 snap nuts that insert into the Side Sill Panels. The stainless steel logo'd sill covers screw into them. It looks like it could be #9 on the below parts diagram, but there is no corresponding part on any of the parts sites. See pics...

Thanks!


IMG_0391.jpgIMG_0380.jpg

[Jack B]

Is that a pressed insert or floating fastener. Most of smaller machine thread fasteners are either 5 or 6 mm. This one is probably 5 mm.

[Gen5snake]

Thanks for chiming in Jack. I can't take a picture of the nut because the rocker panel is on and hides it. The screw is not a machine thread and the snap nut looks like below.


Snap Nut.JPGScrew.JPG

[Jack B]

Thanks for chiming in Jack. I can't take a picture of the nut because the rocker panel is on and hides it. The screw is not a machine thread and the snap nut looks like below.


Snap Nut.JPGScrew.JPG

GOOD Luck in finding one, let us know. I have an inexpensive rivet gun that sets a female insert, that would work and be a more substantial scheme

[SINIS7R]

06507528AA

This should be the correct number!

[pony23]

Might be able to find them at an Auto Body supply store.

[Jack B]

06507528AA

This should be the correct number!

The cost should be interesting.

[J TNT]

As Jack has mentioned , I've used these . https://www.youtube.com/watch?v=cel7FllhxJM

[SINIS7R]

The cost should be interesting.

Looks like $1.00

https://www.viperpartsrackamerica.co...nut-06507528aa

[Gen5snake]

Thanks for the part number! I actually found the picture on that site, but I didn’t know if it was the right nut as The site says it’s for only up to 2010 models. I ordered several To see if it works out.