Gen 1 problems no brake lights and drivers wiper not cycling properly

[09VIPER]

Hello ,looking for some help.Recently bought 94 Viper,getting ready to take in for safety inspection.Have no brake lights,fuse 16 ok.Maybe switch module on brake pedal?part number,where do you get one of these?Also,wipers not synchronizing properly.Drivers side goes up nice and smooth on first cycle,but once passenger side starts,it starts jerking/binding,but does last cycle nice and smooth again.Have to hold it up so they don't interlock.Need new motor on drivers side?works ok on first and last cycle,pass.side works good whole time.If motor bad,y good for F and L cycle but not in between? Maybe bad ground causing both? Any help from anyone with experience would be greatly appreciated?Thanks in advance,Dan

[09VIPER]

Oh ,car has 30'000 kms,not driven much last couple years

[99RT10]

On your wiper issue, The eratic one is the good one, typically. In this case, I believe that you are saying the pass side is smooth? Replace it.

On your other issue, check fuses then if good, go to the brake like switch. I'm assuming that you already checked the bulbs.

[FrankBarba]

You can hard wire the brake light if you can not find the part

[BLRDViper]

I would give JonB a call and discuss the 94 with him. He has lots of knowledge and parts for the early Gen 1's. He can probably save you a some aggravation on working thru your issues.
BLRD
Note: If you do not know already, wait till Tuesday to call.

[09VIPER]

Thanks for help ...pulled wiper arm off pass. side so I could let it run.Heard clicking sound,jacked car up crawled under..finally found module under panel on floor.Yes I will try and give him a call..c if clicking because of bad motor or motor not functioning because module bad.Now go back in shop and play with brake light problem...Thanks again.Worth the price of membership...members have helped me with my 09 ACR,now coming through again!!!Dan