Interest gauging Anodized aluminum replacement for notorious gen 3 plastic door trim

**Viperholic** · 01-14-2019

Originally Posted by nautoncall

I would be interested. I pulled mine off. I got tired of the rattle

This project is on a moratorium at minimum, likely scrapped. Jon B from viper parts rack has a replacement in development, and that is all I hoped for. A viable alternative to a doomed stock piece that was overlooked in production. He has much better resources than I do and will undoubtedly pull it off. Now we wait, patiently. Good things come in time.

I also assumed that this could be tackled by a skilled machinist and made in aluminum, but I spoke before I was informed, and it seems like a nearly impossible project once I understood the challenges. At the least it would be likely cost prohibitive. That was my mistake.

**Zubik** · 04-18-2019

Any update on this? TY

**Getnlwr** · 04-20-2019

I would be interested.

**Rons 2008 SRT 10 Viper** · 04-24-2019

I would be interested. My are like new but I would change them out for future lack of inventory.
Thank you for your involvement.
Rons 2008 Coupe

**J TNT** · 09-04-2019

I have 3 sets of trim pieces replicated if anyone is looking for them . I had them manufactured 40% thicker , where they are known to crack.

**sidwin** · 09-05-2019

pics please. and how hard is it to install?

**J TNT** · 09-05-2019

Here is a picture in this link , if you can remove a door panel then you can replace the strip .
You have a pm.

https://driveviper.com/forums/thread...m-reproduction