Anyone have a Cool Aid setup to sell me

[poorboy]

I understand they were recalled but does anyone still have one in their possession they'd be willing to sell me. I was about to cut into my factory harness to build my own when I noticed the recently updated thread about them, didnt realize anyone had already built something like it for a Viper until reading about it a couple days ago.
Thanks,
David

[Voice of Reason]

I bet most of them were returned. I know I returned mine but reeeeaaaaly didn’t want to as it was doing exactly what it was supposed to. Hopefully Jack is able to swap out the resistor (I think that’s what was used) with one that adjusts the temp just a little less and then he can get these back on the market.

[BJG32]

Contact JackB. Im sure he'd sell you one, but with no guarantee. He recalled them after he heard some knocking in his own car.

[poorboy]

I sent JackB a message asking him about supplying one with no strings attached but haven't heard back from him. If not from him, maybe someone else has one they'll turn loose of.

[ViperGeorge]

I sent JackB a message asking him about supplying one with no strings attached but haven't heard back from him. If not from him, maybe someone else has one they'll turn loose of.

I know Jack put a lot of time and analysis into building his. I used one of Jack's prototypes on the One Lap of America for the drag racing event and I did not notice any problems. However, Jack found it caused his engine to knock under certain circumstances, hence the recall. Do you have an idea for a better mousetrap?

[poorboy]

No sir I don't have a idea for a better mousetrap and was hoping Jack B would be open to selling one with no strings attached. My intentions are to build a completely device for use with my nitrous setup and thought I coud use the Cool Aid piece as a starting point rather than cutting up my existing engine harness. I'm a taker for one with both sides/pieces cut in half with the resistors removed if anybody has one to sell. Basically I'm offering to pay good money for the plugs just for the convenience of not having to cut my harness up. If I strike out on sourcing one I'll be cutting my oem harness up next week.