Need Picture of an ACR E Hood

[RedTanRT/10]

Just bought a used hood that was missing the Fender Vents. I just got the new vents and wanted to make sure I'm attaching them correctly.

Can I ask someone with and ACR-E to post a picture of the underside of the hood with and without the fender vents in.

Looking to understand the correct hardware and how to attach/secure the vents.

thanks!!! Mike

[Fatboy 18]

Check out this thread, it might help you
https://driveviper.com/forums/thread...hood+vent+flew

[RedTanRT/10]

Thanks, but those pictures are of the hood vents not the Fender Vents

[Fatboy 18]

Thanks, but those pictures are of the hood vents not the Fender Vents

HaHa, OK got it, I will search again for you, I did see those while searching

[Fatboy 18]

Any good?
https://driveviper.com/forums/thread...ight=hood+vent

https://driveviper.com/forums/thread...t=fender+vents

[SSGNRDZ_28]

I don't have any without the shield installed but you just insert them from below, stick the 3 tabs in the hood first and then push them in place and use the wingnuts to secure. They will take some manipulation perhaps to get them in place.

19598763_1344040848977048_4732154486109827417_n.jpg
Anodized vent shield installed.jpg

[RedTanRT/10]

Super Doug!! Thanks so much. I need those deluxe wing nuts, probably only $20 each at my friendly Dodge dealer!!

Appreciate the help!! Mike