Results 1 to 22 of 22

Hybrid View

  1. #1

    Glowing manifold

    So i'm about to act like a worried bitc....
    As I'm preparing the viper's engine bay for this weekend car show i saw that the manifold on both sides of the engine is starting to glow as i hold the rpm about 2000 or more..i resently installed smooth tubes&high flow filter.i have seen glowing manifold on other cars at wot but never on low rpms like this..comon on vipers or should i pass the car show and start looking for a problem?big thanks to all answers😊

  2. #2
    VOA Member 99RT10's Avatar
    Join Date
    Oct 2013
    Location
    Banned
    Posts
    3,325
    If you stil have cats, they are probably plugged. Cut them out now!! Hi-flows or natural. I prefer natural
    09 ACR With all the goodies
    99 ACR TT 99 red RT/10 Roe S/C
    97 B/W RT/10 TT 94 RT/10 TT

  3. #3
    the car has hiflow cats(forgot to mention),only one year old.

  4. #4
    Not normal at all at low RPM.

    Any tuning done on the car recently? Timing being off can cause excessive heat in the exhaust as well. I do then to agree with 99RT10 that a cat may be clogged up. If they aren't welded in you may want to try pulling them to see if that fixes the problem.

  5. #5
    No sir,no tuning..i understand its not normal then so i will check your advises,thanks!

  6. #6
    overfuel seems to be, if those are glowing., the cats by now are prolly toast too

  7. #7
    Overfuel?how to fix that?i learn by asking stuppid questions so have mercy

  8. #8
    is it throwing any codes? is the car stock?

  9. #9
    Quote Originally Posted by bluesrt View Post
    is it throwing any codes? is the car stock?
    Only smooth tubes&filter and exhaust uppgrade with hi flow cats.no codes.

  10. #10
    VOA Member 99RT10's Avatar
    Join Date
    Oct 2013
    Location
    Banned
    Posts
    3,325
    Could be a stuck injector or 2?
    09 ACR With all the goodies
    99 ACR TT 99 red RT/10 Roe S/C
    97 B/W RT/10 TT 94 RT/10 TT

  11. #11
    Enthusiast
    Join Date
    Oct 2013
    Location
    Millersville, PA
    Posts
    577
    Why are you holding the throttle at 2k? Do they glow when it idles normally? Holding the throttle with no load on the engine will probably create more heat than normal. You can use a IR temp gun to check to see if the cats are clogged prior to cutting them off and doing a visual.

  12. #12
    Quote Originally Posted by ICPREY View Post
    Why are you holding the throttle at 2k? Do they glow when it idles normally? Holding the throttle with no load on the engine will probably create more heat than normal. You can use a IR temp gun to check to see if the cats are clogged prior to cutting them off and doing a visual.
    Wasnt actually holding it just gave it some rpm above idle(no glowing at idle) and noticed right away the manifolds started to glow,after that i checked by holding the rpm stabil about 2k.😊.i will try a ir temp gun.thanks!

  13. #13
    Enthusiast
    Join Date
    May 2015
    Location
    MacDill AFB
    Posts
    432
    My Bellager headers glowed at idle at the lower bends before the tri-Y merge collector. Both sides did the same thing. No cats. Corsa exhaust system. But then again my tune was rich at idle due to the ROE supercharger system I was running at the time. So I take it you are not running the factory headers/manifolds since the heat shields would cover them up....

  14. #14
    Enthusiast
    Join Date
    Dec 2013
    Location
    Illinois
    Posts
    224
    Quote Originally Posted by ellowviper View Post
    My Bellager headers glowed at idle at the lower bends before the tri-Y merge collector. Both sides did the same thing. No cats. Corsa exhaust system. But then again my tune was rich at idle due to the ROE supercharger system I was running at the time. So I take it you are not running the factory headers/manifolds since the heat shields would cover them up....
    x2. I can confirm on my Paxton Gen 2 with headers, no cats, and 3" exhaust, they would glow red sitting at idle in the garage if I let it run awhile.

    I wouldn't be overly concerned but it doesn't hurt to check.

  15. #15
    Enthusiast
    Join Date
    Dec 2013
    Location
    Mass
    Posts
    1,079
    Are they red all the way across or just at certain spots / cylinder?

  16. #16
    Quote Originally Posted by daveg View Post
    Are they red all the way across or just at certain spots / cylinder?
    A little diffucult to tell as i'm running the stock manifold with shields,when it gets hot it realy lights up under the shield.i will be taking the car to a mechanic next week just to be safe

  17. #17
    Enthusiast
    Join Date
    Mar 2014
    Location
    Guelph
    Posts
    14
    I have Corsa with new 3" kooks green cats. With the car idling on the hoist I can see a slight cherry red glow from underneath with the hood shut. Otherwise my car is stock with smoothtubes. Stock manifolds are thin, i wouldn't be to concerned unless they are glowing.

  18. #18
    Moderator
    plumcrazy's Avatar
    Join Date
    Oct 2013
    Location
    ALL OVER
    Posts
    3,011
    if your cats are clogged, you will cause some SERIOUSLY bad engine issues by driving it. dont ask me how i know this....
    THE IGNORE FEATURE WORKS, TRY IT...

  19. #19
    Enthusiast
    Join Date
    Oct 2013
    Location
    Ohio
    Posts
    3,889
    It is easy to verify if the cats are plugged. Measure the temps on both sides of the cats. If you have a large differential (hotter on the engine side) your cats are plugged or partially plugged. You can start a fire if they are plugged and try to run the engine. I have run Belangers on three different vipers and have never seen them glow at low speeds or no load conditions.


    Quote Originally Posted by plumcrazy View Post
    if your cats are clogged, you will cause some SERIOUSLY bad engine issues by driving it. dont ask me how i know this....
    Last edited by Jack B; 04-29-2017 at 09:40 PM.

  20. #20
    Enthusiast
    Join Date
    Apr 2016
    Location
    Sherwood Park, AB
    Posts
    1,039
    Cats are over-rated anyway. Just cut 'em out

  21. #21
    Web Site Committee
    Moderator
    Tech Team
    City's Avatar
    Join Date
    Oct 2013
    Location
    Nu Yawk
    Posts
    2,941
    Please keep us updated. ANd make sure to ask Plum how he knows.
    2008 SRT10 Open Roof (1 of 2)
    2022 BMW X5M Comp
    Resident Misanthrope

  22. #22
    Enthusiast
    Join Date
    Oct 2013
    Location
    Dothan, AL
    Posts
    7
    Check with a wrench to see if your front O2 sensors are loose. This will cause your manifolds to glow red and can destroy the sensor if driven or ran for too long. A few heat cycles can easily back out an otherwise "snugged in" oxygen sensor.


 

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •