Results 1 to 17 of 17
  1. #1

    Wet passenger side floor

    I have had a water problem with my 98 GTS on the passenger side floor. I have searched the forums and have tried to clean the a/c drain tube with a wire, garden hose , and a low power air compressor. Any other suggestions I would really appreciate it thanks in advance and sorry to bring up such a old thread

  2. #2
    Enthusiast
    Join Date
    Jun 2016
    Location
    Murphy
    Posts
    112
    Just to make sure, you had not driven it in the rain or washed it?

  3. #3
    Enthusiast
    Join Date
    Oct 2013
    Location
    South of London, Surrey
    Posts
    7,577
    Sounds like you may have a leak from the small heater radiator in the car? Can you smell Coolant? Sort of a sweet smell usually.

  4. #4
    Enthusiast
    Join Date
    Oct 2014
    Location
    Driving around with contaminated fluids braking at 95% while squirting WD40 in people's locks
    Posts
    3,036
    Check the foam seal where the heater hoses go into the heater core. Open the hood and it's above the passenger footwell right by the heater core valve. That foam can deteriorate over time and leak water in.

  5. #5

  6. #6
    Thank you all for helping me out with this problem I really appreciate it. Just wanted to answer a few of the questions some of the guys asked. The passenger side of the floor would get soaking wet if I left her outside even with the factory car cover on it especially if it rained very hard. The car doesn't have that antifreeze smell going on so I don't believe it's a leak from the radiator system. Dave6666 mentioned something I have not looked into regarding the foam seal deteriorating around the hoses that go into the heater core. If that's what's causing my leak what do you recommend to fix it ? Can I order new foam or should I use silicon. Thanks for helping me out with this problem

  7. #7
    Perhaps you scared your passenger to the point they relieved themselves?

  8. #8
    Quote Originally Posted by pitdad View Post
    Perhaps you scared your passenger to the point they relieved themselves?
    Interesting theory...might want to look into this one

  9. #9
    Enthusiast
    Join Date
    Oct 2014
    Location
    Driving around with contaminated fluids braking at 95% while squirting WD40 in people's locks
    Posts
    3,036
    Quote Originally Posted by Silver GTS View Post
    Can I order new foam or should I use silicon.
    The foam is no longer available although you could make a piece that would work. The problem is the disassembly needed to get access to that area is somewhat huge.

    Using an RTV sealer from the outside would be way easier if you decide that's the entry point. Very odd that it comes through a car cover tho. Yet the rest of the car does not get wet?

    BTW, "silicon" is a rock hard element (Si) that they use to make computer chips. Silicone is what RTV sealants are called.

  10. #10
    Enthusiast
    Join Date
    Oct 2014
    Location
    Driving around with contaminated fluids braking at 95% while squirting WD40 in people's locks
    Posts
    3,036
    Here is that seal from a spare HVAC box I have. It goes inside the part you see with the hood up. Relatively big job.


  11. #11
    Enthusiast
    Join Date
    Jun 2016
    Location
    Murphy
    Posts
    112
    If if is from rain, check the seal around the rear of the window near the B pillar trim mounting point. That is where mine leaks in the rain and gets the floor wet by the foot well.

    bpillar.jpg

  12. #12
    Enthusiast
    Join Date
    Jan 2017
    Location
    Western, Massachusetts
    Posts
    6
    Hi, this is Ed Adamchek, new member of New England Region, and I had a similar issue on my driver's side, back in 2007. Since my car is red, I bought some red silicone hose, approx. 3/8" I.D., then by using mix-n-match hose couplers, similar to vacuum line splitters or connectors, I connected the hose to the drain from the cosmetic, screened, left side hood depression (I think I used a 90 degree connector. Then, using Goop Advanced Automotive or Goop 6000 (I LOVE THAT STUFF) and some high-quality duct tape, I secured the hose to the underside of the hood, down to just behind the left wheel well, Gooping a section, then duct taping it into place, about 6" at a time, cutting the tubing to end just 1/4" or 1/2" above the bottom hood edge, and draining down into the side-exhaust cover. Haven't had a wet ankle when caught in the rain since. Hope this helps P.S. Drive the car for a few days before carefully removing the duct tape & then either a solvent or penetrating oil to remove the duct tape adhesive left behind.

  13. #13
    Enthusiast
    Join Date
    Oct 2014
    Location
    Driving around with contaminated fluids braking at 95% while squirting WD40 in people's locks
    Posts
    3,036
    Quote Originally Posted by white out View Post
    Check to make sure the plug in the floor is still there.
    Those go in from the inside don't they?

  14. #14
    I want to thank everyone for all the great tips and suggestions including photos/diagrams very cool of you all. I drove the car about 60 miles on Sunday and checked the passenger floor & the HVAC system a dozen times and it stayed dry. I have the car outside with the factory cover on it and it's supposed to rain hard for the next few days, I will keep you posted and let you know if I get any water problems & will use your suggestions to hopefully fix this problem

  15. #15
    Enthusiast
    Join Date
    Nov 2013
    Location
    Germany
    Posts
    992
    Glad you fixed the problem! One other question comes to my mind reading your post: is the factory car cover designed for outdoor use? I always thought it is not....!? Thanks.

  16. #16
    Enthusiast
    Join Date
    Oct 2014
    Location
    Driving around with contaminated fluids braking at 95% while squirting WD40 in people's locks
    Posts
    3,036
    Quote Originally Posted by Silver GTS View Post
    I will keep you posted and let you know if I get any water problems & will use your suggestions to hopefully fix this problem

    Quote Originally Posted by My98RT10 View Post
    Glad you fixed the problem!

    Read much? He clearly states he hasn't done anything yet.

  17. #17
    Enthusiast
    Join Date
    Nov 2013
    Location
    Germany
    Posts
    992
    Quote Originally Posted by dave6666 View Post
    Read much? He clearly states he hasn't done anything yet.
    Well, then "Glad that without having done anything yet your issue has not returned!"


 

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •