What's the going rate for a clutch and flywheel install?

[Troublemaker]

I have done a few clutches in other vehicles, but just don't have the time and would feel better about having someone that is familiar with Vipers doing the job right the first time. Has anybody had it done that might happen to remember a ballpark figure for the labor, I have purchased all the parts already.

[99RT10]

Figure about $300-$500 for labor. $250-$500 for parts, depending on the type of clutch. Going back stock? Or............:

http://driveviper.com/classifieds/ac...-3-clutch.html

[Troublemaker]

No, I picked up a Spec 2 and Fidanza. I have to have an oil leak on the galley plug fixed so it is just a good time to upgrade.

[Dan Cragin]

When you replace your clutch and flywheel, always replace the pilot bearing, slave cylinder (with throwout bearing), flywheel bolts, driveshaft straps and bolts. Typical labor charge is about $400.

[Troublemaker]

When you replace your clutch and flywheel, always replace the pilot bearing, slave cylinder (with throwout bearing), flywheel bolts, driveshaft straps and bolts. Typical labor charge is about $400.

Good to know Dan, thanks. I'm sure they can still be added to the order.