Results 1 to 11 of 11
  1. #1
    Enthusiast
    Join Date
    Nov 2013
    Location
    Inverness, IL
    Posts
    556

    Clearbra ACR spoiler

    Anybody do it? Weird thought but can't the rocks from the front fenders being open on the extreme kick up rocks onto the spoiler as well? Wondering if the 1mm (or however thick) would change the aerodynamics?

  2. #2
    My entire ACR is wrapped in Xpel including the wing.

  3. #3
    Enthusiast
    Join Date
    Dec 2015
    Location
    Los Angeles
    Posts
    544
    Quote Originally Posted by greygt3 View Post
    My entire ACR is wrapped in Xpel including the wing.
    How much does that run in the US? Need to know as having mine done for the first time there too. Pls PM me if you're happy to disclose.

    Thanks in advance.

  4. #4
    Enthusiast
    Join Date
    Nov 2014
    Location
    Bay Area, CA
    Posts
    1,053
    The wing will get hit by road debris. My clearbra has already saved my wing of a few good rock chips.

  5. #5
    As above, my entire car is covered and the wing gets hit!!

  6. #6
    Enthusiast
    Join Date
    Oct 2013
    Location
    Washington, IL
    Posts
    1,739
    I'm surprised they didn't do your wing while they were doing the rest of the car. I'd have them come to your house to finish the job.

  7. #7
    Enthusiast
    Join Date
    Nov 2013
    Location
    Blair, Nebraska
    Posts
    3,804
    At least do the leading edge in an inch or more - above and below.

  8. #8
    Enthusiast
    Join Date
    Nov 2013
    Location
    Inverness, IL
    Posts
    556
    Quote Originally Posted by Voice of Reason View Post
    I'm surprised they didn't do your wing while they were doing the rest of the car. I'd have them come to your house to finish the job.
    Agreed. The entire thing is wrapped except for the wing. Alright, I'll make it happen.

  9. #9
    I have chips on the end plates. Going to take them off and get them repainted this summer and then clear bra them. It was a mistake to not do them sooner.

  10. #10
    Where did you get chips on the end plates? I have the outside and leading edges done, not the inside.

  11. #11
    Leading edges


 

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •