Anybody do it? Weird thought but can't the rocks from the front fenders being open on the extreme kick up rocks onto the spoiler as well? Wondering if the 1mm (or however thick) would change the aerodynamics?
Anybody do it? Weird thought but can't the rocks from the front fenders being open on the extreme kick up rocks onto the spoiler as well? Wondering if the 1mm (or however thick) would change the aerodynamics?
My entire ACR is wrapped in Xpel including the wing.
The wing will get hit by road debris. My clearbra has already saved my wing of a few good rock chips.
As above, my entire car is covered and the wing gets hit!!
I'm surprised they didn't do your wing while they were doing the rest of the car. I'd have them come to your house to finish the job.
At least do the leading edge in an inch or more - above and below.
I have chips on the end plates. Going to take them off and get them repainted this summer and then clear bra them. It was a mistake to not do them sooner.
Where did you get chips on the end plates? I have the outside and leading edges done, not the inside.
Leading edges
Bookmarks