I bought the Arrow Tune, need a dealer to install it. Any one know a good dealership?
I bought the Arrow Tune, need a dealer to install it. Any one know a good dealership?
LOL, there is absolutely zero dealers in NJ id trust to touch a viper...zero
THE IGNORE FEATURE WORKS, TRY IT...
If you're willing to travel down the turnpike, you can take the car to D'Ambrosio's in Downingtown. Jeff Palmer is the Viper tech there. Many of us locals here use him.
A little bit of a ride but these guys know their way around a Viper. He does some of Tator's tuning.
https://www.facebook.com/Powerplant-...03508/?fref=ts
I will second the Powerplant reps. Great guys and know what they are doing with tuning and a Viper!
None whatsoever. Scott has been around forever back to his days at Warnock. He did all 3 of my recalls while I waited. They are right off of the Henry Hudson Pkwy. I took the Lincoln Tunnel in and the GW Bridge back. I wound up behind an F-Type Jag in the tunnel so we made some great music together.
This was exactly what I was going to start a thread on. Looks like I will be ordering my Arrow Tune and heading to Powerplant Motors since it's only an hour from me. V10JOEY, did you go with them or someone else?
Sent both mine down to Andy at Viper Exchange in Texas!! Arrow tune and full exhaust- freight sucked but so worth it IMO!!
fyi, i did not have good luck with him at warnock, id never let him near a viper
THE IGNORE FEATURE WORKS, TRY IT...
In another thread someone mentioned Ramsey Dodge and to request a Pete, however, there's no Pete there. There is, however, a Mark. Is that familiar to anyone?
pete USED to be there. if i knew where he was, id highly recommend him. dude knows his stuff !
THE IGNORE FEATURE WORKS, TRY IT...
For what it's worth I'm scheduled to go to Carmel Meadowlands in NY next week for recalls. Apparently CJ is a good viper tech there, according to Chuck Tator
Swexlin & Ruski, I read on another thread that you both had the R28-29 recalls done. Would you or anyone else mind telling us the dealers you used and how they were to deal with. Thanks in advance.
Bill
I had mine done by Jeff Palmer, Viper Tech at D'Ambrosio's in Downingtown, PA, today, actually. He' great to work with, and he had both done in about 2 hours. He even lets me go back and see the car as he's working on it. PM me if you want the phone number. Here's my reply in the other thread:
All done. So, my car hadn't been started in 6 weeks, but it was in hibernation mode. It was 18 this morning in my garage. Starting took 3-4 tries, and she finally whummped-whummmped-whummped to life. By the time I drove 10 miles to the dealer, battery was showing normal 14.4 V, and on the way back as well. Center touch screen didn't work the whole way down to the dealer. I had him check it out, but it's working now. My tech said it was probably just so cold from sitting that long. Didn't do it last winter, but whatever.
So, he did the R28, R29, and the R14 door handle as well. I had NO oil on the old air filter, so that's a good sign. Said should hear something back in 10 days-2 weeks.
By the way, the door handle, he has to order the passenger side handle again - the one they sent doesn't fit quite right. Assuming everything is OK, I have to take the car back in the spring to put my new tires on, so he'll correct it then
Last edited by swexlin; 02-19-2016 at 03:14 PM.
Bookmarks