Cat-less BB header and MOPAR race exhaust sounds like an explosion when it pops during start. After that not to bad.
https://www.youtube.com/watch?v=h2L5TDR9fxk
Type: Posts; User: pokeyl
Cat-less BB header and MOPAR race exhaust sounds like an explosion when it pops during start. After that not to bad.
https://www.youtube.com/watch?v=h2L5TDR9fxk
Got it 20A CIG LGT
What fuse powers the ODBII port? Location? Thanks in advance.
OK amazon sent the wrong side. But all I needed was the motor so I swapped it into the old housing. Works perfect.
So if you have a Dead Motor, just buy a 2015 or newer challenger motor assy and...
Internet search Amazon had one left $60 it is on the way
An one have a driver side window motor? My track is good, motors are $200 but all vendors are out of stock. Don't want to drop $600 is I don't have to. Thanks
Just booked the hotel. First time.
Driver side windows auto rolls down to open the door but not the full auto down. And it wont roll back up when you close the door.
Passenger works find.
I have done the relearn and it just...
19 inch 305,s will not work, Trust Me, Not on Forgestar Wheels, I tried. Went back to 295/25-19 and all is fine now.
The car undriveable due to scrub radius changes.
Did you have to make a new hole?
Setting up WB O2 need to get the wiring into the cabin, what is the best path.
Gen3 Thanks.
I will check. Last week at the autocross all starts were good with the cover off and living the hood up between runs.
Starts were not all good last year with only the hood up.
More data to...
Changed the starter relay, no help. But I took the under hood fuse box cove roff and the relays are so hot you can't touch them. took out the starter relay cooled it off starts right up.
I put CCM on my front, it steers lighter always! Bite is not as good as steel. There is always a trade-off.
I played with this, ended up using it on another project.
https://driveviper.com/forums/threads/25929-Li-Bat-install
Thanks
I bought a DRBIII from someone that rebuilds them. Now I have lost his address and number. Anyone have his data, I think is So Cal area. Thanks
It's my first time!
Buy a set at auto zone.
Cut off the old rubber from the viper wiper, cut the new from the auto zone wiper.
Glue new rubber onto old wiper.
Viper tax avoided!
Just talked to Cory, huge help. Thanks to all.
You have a number, I'm an old spoon-feed dude. Thanks
Are there any for Gen3-4 cars?
Forgeline has 18" that fit.
A few forged 18" wheels fit, very tight! Go 19 inch to be safe.
OK, the big difference is the rear rotors are 4mm in-board, making you change the rear knuckles. I put the 390mm CCM on the front and stayed stock in the rear. So far no problems at low speed, hard...