Boosted Map sensor

[T/A KID]

What Map sensor is everyone using on boost applications using stock ECM??
I see the factory tune can be calibrated up to 500kpa in the scaler so inputting data won’t be an issue.. the MAF has a large flow range as well so up to 10lbs shouldn’t be and issue…

Looking for something plug and play.. not sure the SRT neon would fit the bill here in figment and connector??


Worst case I can retrofit a GM ls9 3 bar map, but if something is available that’s plug and play replacement that would be ideal

[Arizona Vipers]

ViperToad on here should know.....

[T/A KID]

ViperToad on here should know.....

Nice! Hopefully he responds, may send him a PM!

Hellcat/demon Map may work as well

[LATAMUD]

Use one for SRT-4

[T/A KID]

Use one for SRT-4

Thanks, figured it was what was used. Do you know if it’s a plug and play swap? Naturally the map data needs to be changed in tune, but if it’s a direct swap that’s be perfect

[CNU_Physics]

Wouldn't a Hellcat have a MAP sensor you could use?

[T/A KID]

Wouldn't a Hellcat have a MAP sensor you could use?

Of course… but not sure if it’s plug and play (same connector and nipple size)

[LATAMUD]

The factory SRT-4 is 2 BAR MAP, plugs right in, direct replacement.

[T/A KID]

The factory SRT-4 is 2 BAR MAP, plugs right in, direct replacement.

Perfect!! That’s the sensor to use then! Thanks