mass air sensor connectors

[Sniper]

How do you unplug The two mass air sensor connectors?
48399

[Steve M]

Looks like you are missing the little red lock things...that being the case, just press on the tab close to the wires and pull straight back.

[Sniper]

Ok, I got those off.
Now here’s the rest of the instructions:
Remove grommet
o Remove the rubber grommet from the center mounting point
- Remove and Reuse factory nut clips
Is this the rubber grommet to remove?
48400
48402
o Remove the two factory clip nuts from the radiator area by lifting on the center section so they can slide
easily off of the radiator support. (These are the clip nuts that previously secured the front of the airbox with
the thumbscrews.)

How do you get these off because they’re not easily sliding off?
48401

[Steve M]

Yes on the rubber grommet...it'll pull out with a little tugging.

The speed nuts (the clips) you may have to pry on...just put a small flathead screwdriver under it and lift up a bit if it isn't sliding off.

[Sniper]

48406


Can I put this air box and heat shield on the car and screw these:
48404

Into these???
48405

Instructions say to take the nut screws out and put on heat shield and only mount the heat shield to the air box and not the car itself…
If anyone can enlighten me?

[Sniper]

Making progress, hopefully have this done by tomorrow.
I’ve got the heat shield covered with dynaliner.
48407

[Sniper]

Another question:
Do you recommend not cutting the drain plug?
And if you recommend cutting it, where do you recommend cutting it?
48408

[Sniper]

No response so I didn’t cut the nipple.
Finally got it all together and that was not fun LOL!
48417

48418

[Sniper]

Thank you, Steve!!!!!!!