PDA

View Full Version : Oil Pressure 0 100


SRTGill
04-20-2021, 10:52 PM
Hello, I have a 2014 GTS. Took the car out for a spin around town. While sitting at a stop light the oil pressure guage started to flash and read 0. Then when I started to drive so I could pull over somewhere the pressure read over 100. This kept on happening, luckily being close to home I brought it back. First time ever couldn't wait to turn the car off lol (nervous laugh). Waited 5 mins to check oil level and it read full. No weird noises in the motor either. Any thoughts?
Whiskey
04-20-2021, 11:41 PM
Assuming the oil level is good I check the connection and wires for the oil pressure sensor.
SRTGill
04-20-2021, 11:42 PM
Assuming the oil level is good I check the connection and wires for the oil pressure sensor.

Location of this sensor?
98intrigue
04-21-2021, 01:43 AM
Location of this sensor?

It's somewhat of a common issue from reading this forum. The link below says "lower passenger side front of the engine".

https://driveviper.com/forums/threads/8256-Did-my-car-go-into-limp-mode/page2
SRTGill
04-21-2021, 09:24 AM
It's somewhat of a common issue from reading this forum. The link below says "lower passenger side front of the engine".

https://driveviper.com/forums/threads/8256-Did-my-car-go-into-limp-mode/page2

Copy, will try to find that. Going through that thread might need a sensor also
Hootie
04-21-2021, 02:00 PM
In case it helps.
https://i.ibb.co/rw8Zm5t/Wiring.pnghttps://i.ibb.co/zGpXg8j/Untitled.png

Sensor torque is 80in-lbs from the tech manual.
SRTGill
04-21-2021, 05:17 PM
I see the sensor, but cant seem to get the connector off. Any tips?
swexlin
04-21-2021, 06:50 PM
Common issue across the Dodge/Jeep line it seems. I seen it on this board several times.
SRT BILL
04-21-2021, 09:22 PM
I see the sensor, but cant seem to get the connector off. Any tips?

SRT Gill, You have to move the red blade to open switch. Search for "changing oil presure sensor genv"

there is a picture of the switch in that post.
wakeupluis
04-21-2021, 11:39 PM
Mine did the same thing. It was the oil switch. I went to local Dodge Dealer. Picked one up for pretty cheap. Same one they use on many vehicles. I bit of a pain to install but not impossible and I have very large fat hands so that made it a bit more difficult. I think it took me about 30 minutes to replace.
SRTGill
04-22-2021, 02:23 PM
All set now, thanks everyone. The viper lives for another day!