View Full Version : big gains on just cam swap zero head work gen 3
chicagopd50
06-24-2020, 11:53 AM
https://www.youtube.com/watch?v=PGDCbY7N3lE
99RT10
06-24-2020, 12:22 PM
If you would have ported/polished the heads, you would have been 620 RWHP easily. That said, sounds good!!! Did you do the cam swap without pulling the heads?
Vipes
06-24-2020, 12:32 PM
That’s actually pretty cool someone finally did this. I always wondered how much of the power gains were from ported heads and how much was from the cam in a h/c package. Nice results!
chicagopd50
06-24-2020, 12:46 PM
heads were pulled off i did change lifters and push rods..
chicagopd50
06-24-2020, 12:48 PM
If you would have ported/polished the heads, you would have been 620 RWHP easily. That said, sounds good!!! Did you do the cam swap without pulling the heads?
not really i seen some do heads and cam on gen 3 and gain just about what i gained.. and dont forget i was dynoed on a mustang dyno which would be around 625 -640 range on a dyno jet
Steve M
06-24-2020, 01:35 PM
Sounds healthy...very nice!
Ameration
06-24-2020, 08:56 PM
What exhaust set-up were/are you running on there?
That's pretty amazing results.
chicagopd50
06-25-2020, 10:47 AM
i had high flow cat deletes and borla cat backs, stock headers...
PRVT JET
06-25-2020, 01:35 PM
i had high flow cat deletes and borla cat backs, stock headers...
Where did you Dyno? Did Albert work on your car???
Isaac
J TNT
06-25-2020, 06:18 PM
Nice work , congrats !
Powered by vBulletin® Version 4.2.4 Beta 1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.