PDA

View Full Version : Anyone know the thread size on the bottom of the shifter isolator


Beaker
08-10-2019, 02:35 PM
39577
Old School
08-10-2019, 02:38 PM
It's metric - M12x1.75. I used one of these as a shifter handle:

https://www.ebay.com/itm/TE-CO-Dbl-Thd-Stud-M12x1-75x175mmOAL-PK2-60557/253007439395?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
Beaker
08-10-2019, 05:22 PM
May I present, the 6$ short throw shifter . . . .

39578

39579

39580
Old School
08-11-2019, 08:12 AM
^^^ These are the kind of solutions I like, they don't have the "Viper tax" added.
Old School
08-13-2019, 11:10 AM
GRADE 8 OR 5 BOLT? the newer ipsco ones come with the sealing ring for the environmental boot, you will want to try to seal that up to reduce fumes

Yes, either grade 5 or 8, you want a hardened bolt/stud. On mine, I slid a short piece of fuel line on the stud, then a short piece of heater hose over that to provide the seal to the lower boot. I also zip tied the boot to the heater hose.