Measurement help

[13COBRA]

When someone has time, I'm in no rush, could you measure the distance from the top of the rear bulkhead to the ceiling (above the harness bolt holes), on your Gen V?

I'm wanting to put one of Ross Murray's roll bars in my Gen IV ACR, and I really like the look of his Gen V bars better than the IVs. I'm hoping I can get away with just cutting the rear bulkhead to allow for the vertical bars to pass through.

Yes, I know the Gen V is carpet while the Gen IV is plastic.

I'd apreciate the help!

[13COBRA]

Ross Murray's roll bars are very nice pieces and I really would like to have a couple myself. Just not in my budget at the moment. But I do have a Gen 4 and 5 sitting side by side in the garage and I will take some measurements first thing tomorrow for you.

So he makes two different roll bars one for each Gen?.... Is this correct?

I only ask because I saw a pic of a Gen 4 with one of his roll bars and it looked like the same roll bar that he makes for the Gen 5.

The Gen IV and V differ with how/where the front bars connect to the car. I'd prefer to have it connect to the harness bolts (Gen V) instead of the floor (Gen IV).

There is less modification that way.

[13COBRA]

Looks like about 6 1/4" at the point you mentioned this is on a Gen 5

Good luck

Thank you very much!