Jacking/ pucks

[TT32VGT]

How are you guys jacking your gen v? Do they have a spot to use a puck? If so where's a good place to buy the pucks? Thx

[FSTENUF]

Behind the front tires and in front of the rear tires. Look under and you can see the all 4.

[sharmut]

For the rear, the metal pan has a square opening located just behind the rear diff. Use a hockey puck purchased from Amazon fits perfectly there.

[sadil]

You don't need a puck for the 4 corner spots. There is a inverted trianglular shaped lift point. My jack and jack stands have soft pads. I did buy a puck thinking I needed it for the sides but then realized it fit perfectly within the rear slot under the diff to lift the rear end up. For a better weight distribution while jacked, I put stands under the engine mounts on the front instead of using the front jacking points I mentioned above. Good luck.

[kaamacat]

How are you guys jacking your gen v? Do they have a spot to use a puck? If so where's a good place to buy the pucks? Thx

I made a set of pucks for various uses. (some for pinch weld lifting on some cars)....but. Just head to your local sports
store and pick up a pack of hard rubber hockey pucks. I routed out the center and about 3/8" deep x 3/8" wide...it varies.

[ForTehNguyen]

sack o pucks, 12 for $16.50

https://www.amazon.com/Faswin-Classic-Ice-Hockey-Puck/dp/B01FQ6H3V6/ref=sr_1_4?s=sporting-goods&ie=UTF8&qid=1508254259&sr=1-4&keywords=hockey+pucks

[Viper vince]

I made a V block for my floor jack

[darbgnik]

FYI, you can service both front and rear tires on the same side by using the rear jack point, the car is stiff enough.