Clutch alignment tool needed

[steve911]

Hi all,

Does anyone have a source for a clutch alignment tool to fit a GEN 4/5? I have one for a Gen 1-3 car but the pilot at the end of the splines it's not long enough to engage the pilot bearing with both of the clutch discs in a GEN 4/5 clutch.

Thanks advance.

[Jack B]

I bought mine from Woodhouse.


Hi all,

Does anyone have a source for a clutch alignment tool to fit a GEN 4/5? I have one for a Gen 1-3 car but the pilot at the end of the splines it's not long enough to engage the pilot bearing with both of the clutch discs in a GEN 4/5 clutch.

Thanks advance.

[Steve M]

How long do the splines need to be? I have this one from Quarter Master, but have never used it on a Viper - I bought it when I installed an RPS carbon/carbon twin on my old Camaro with a T-56. It has about 3" of splines:

http://i305.photobucket.com/albums/nn227/meentss02/Clutch%20Alignment%20Tool_zpswtqkt8yw.jpg

Link: http://www.quartermasterusa.com/qm/spline-alignment-tool-1-5-32-x-26-input-shafthtml/

[Jack B]

The Mopar tool I have is 5-1/2" from the pilot end tip to the end of the splines. The Mopar # is 10018A.


How long do the splines need to be? I have this one from Quarter Master, but have never used it on a Viper - I bought it when I installed an RPS carbon/carbon twin on my old Camaro with a T-56. It has about 3" of splines:

http://i305.photobucket.com/albums/nn227/meentss02/Clutch%20Alignment%20Tool_zpswtqkt8yw.jpg

Link: http://www.quartermasterusa.com/qm/spline-alignment-tool-1-5-32-x-26-input-shafthtml/