Rocket
03-08-2016, 07:24 PM
Thanks to all that have contributed info regarding their catch can set-up. I put together my setup using the Radium Engineering Single Universal Catch Can PN 20-0008, 2 each of the Fragola Part # 499210-BL Low Profile -10 AN Male To -10 AN O-Ring 90 Degree Fittings, 1 of the PRE-21000BLK -10 AN Push Lock Straight Swivel Hose End, 1 of the FRA- 209010-BL Fragola -10 AN 90 Degree Push Lock Lok Swivel Hose End Fitting Black, and 3 feet of Black -10 AN Push Lok Loc Lock Hose Line Fuel Coolant 5/8" Synthetic Rubber Hose. My total cost for this set-up was $234.22. Total install time was about an hour. The Radium Engineering Catch Can came with a mount and I drilled into the cross support and used sheet metal screws to attach. Heated up the end of the hose in hot water before pushing it onto the push fittings. Just installed it, so no reports yet of how much oil it may collect. The Radium Engineering catch can is a closed system,uses a “dip stick” to test how much oil is collected, and the bottom of the unit unscrews when it needs emptying.
http://driveviper.com/gallery/data/500/medium/Rocket_Gen_4_Catch_Can.jpg
http://driveviper.com/gallery/data/500/medium/Rocket_Gen_4_Catch_Can.jpg